todd
New Member
Posts: 4
|
Post by todd on Aug 20, 2017 18:26:15 GMT -7
I had my system working great for months and today tried to unlink from REF014C reflector and could not. I get a RPT? in the icom window meaning it didn't get through. Everything looks fine in the 9100 and haven't touched the software. The linking is ok with start-up and links to REF014C. I'm thinking it is something in the Icom but not sure. I'm using the GMSK shield with RP3/Arduino. Anybody have any suggestions? Anything appreciated. Todd AL7PX
|
|
|
Post by W6KD on Aug 21, 2017 10:29:18 GMT -7
What software and version number on the hotspot?
What is programmed into the radio for the unlink (URCALL, MYCALL. RPT1 and RPT2)?
Regards
|
|
todd
New Member
Posts: 4
|
Post by todd on Aug 21, 2017 12:25:46 GMT -7
Thanks for the reply Bob. Got it working. Did a partial reset the day before on 9100 which changed DUP offset back to default (.600Khz). Radio needs DUP set but set frequency offset to zero (0.000). Dstar Radio was transmitting on wrong frequency to high power hotspot radio. Thanks, Todd AL7PX
|
|