dv mega pi3 and dstar commander
Sept 21, 2016 13:39:43 GMT -7
Post by falcon on Sept 21, 2016 13:39:43 GMT -7
I have been running the dvmini on the pi3 with no problems with either dmr or dstar after talking to several people running the dvmega and hearing how good they sounded i purchased a dvmega and it arrived last friday.
So i downloaded dstar commander used 7zip to unpack it and win32 disk imager and burned it to the mini sd card.
I then sniffed for the ip and vnc'd into it and set everything up in the repeater and ircddb gateway set up both per the directions from the enclosed pdf set up guide.
Also i set it up to connect to 001c upon boot up and it does.
However i get no receive audio nor transmit audio and yes i do know you have to change back to cqcqcq to pass transmit audio.
also i get an invalid repeater command rpt 1 followed by my call sign i have no idea why or what is causing it as i ave went through the set up several times.
The only command that works is the reboot command i cannot link or un link from the id 51a to change reflectors the only way i can connect is by setting the auto connect in the ircddb set up.
any help would be wonderful at this point i would be willing to let someone remote desktop and i could have the sd card from the radio plugged in and the programming software running and the pi running so all could be checked and corrected as necessary.
73's to all.
N8LLC.
John.
So i downloaded dstar commander used 7zip to unpack it and win32 disk imager and burned it to the mini sd card.
I then sniffed for the ip and vnc'd into it and set everything up in the repeater and ircddb gateway set up both per the directions from the enclosed pdf set up guide.
Also i set it up to connect to 001c upon boot up and it does.
However i get no receive audio nor transmit audio and yes i do know you have to change back to cqcqcq to pass transmit audio.
also i get an invalid repeater command rpt 1 followed by my call sign i have no idea why or what is causing it as i ave went through the set up several times.
The only command that works is the reboot command i cannot link or un link from the id 51a to change reflectors the only way i can connect is by setting the auto connect in the ircddb set up.
any help would be wonderful at this point i would be willing to let someone remote desktop and i could have the sd card from the radio plugged in and the programming software running and the pi running so all could be checked and corrected as necessary.
73's to all.
N8LLC.
John.
