RPT? Issue

Get rid of all these port forwarding entries--they are not needed with DStar Commander and can cause things to stop working on other computers as well. The image is set up so that no explicit port forwarding is required for it to work.

You do not need or want to have your gateway modules registered in the trust server. I note that you have suffixes "B" and "C" registered, and these are normally used as modules on a gateway. The only suffixes that should be registered are those used by user nodes--IOW, radios or dongles. Frankly, you'd be much better off to start with ONLY your callsign (blank suffix) registered. If you are having receive-only connect issues, it's probably because you are using a registered user callsign as a gateway module.

Here's how I recommend you proceed:

1: Go into your DStar Registration server at W9HEQ and deregister everything except KD9CHO with a blank suffix (the first entry).

2: Get rid of all the port forwarding entries mentioned above in your router and reboot it.

3: Reflash your SD card with DStar Commander, and set it up to run as module "D" for now. (You can use modules B/C later after some time has passed to allow the changes made in step #1 to propagate around the system--give it a good day just to be sure)

4: Set MYCALL in your radio to KD9CHO (no suffix).

Things should start working after making those changes.

Regards