After a RF Halt command, System continues to Halt.

kc9zmy
New Member

Posts: 3

After a RF Halt command, System continues to Halt. Mar 29, 2015 17:59:02 GMT -7

Quote

Post by kc9zmy on Mar 29, 2015 17:59:02 GMT -7

Has anyone seen problem where after you issue a RF halt command the system continues to halt after about 4 to 5 min. The only way I have found to stop the Halts is to reimage the system. I can get in with VNC but can't figure out what flag, file or config option is set that would cause the system to halt. I've had to reimage the system 3 times so far so I don't know what I'm doing wrong.

Any Hints?

W6KD Administrator Posts: 419	After a RF Halt command, System continues to Halt. Mar 30, 2015 7:49:08 GMT -7 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by W6KD on Mar 30, 2015 7:49:08 GMT -7 This can be caused by resetting the time zone in the Pi--as explained in the docs, leave it set to UTC. Regards
	Bob (W6KD) Colorado Springs, CO D*STAR Hangouts: XRF555A (persistently linked to XRF002A) XRF720C (Colorado Front Range reflector)

kc9zmy New Member Posts: 3	After a RF Halt command, System continues to Halt. Mar 30, 2015 22:02:12 GMT -7 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by kc9zmy on Mar 30, 2015 22:02:12 GMT -7 Thanks for the quick reply. I had changed my time zone. One of those basic steps I do when I set up the system. I will leave it alone!

After a RF Halt command, System continues to Halt.

Post by kc9zmy on Mar 29, 2015 17:59:02 GMT -7

Post by W6KD on Mar 30, 2015 7:49:08 GMT -7

Post by kc9zmy on Mar 30, 2015 22:02:12 GMT -7